Oatey SOLAR Roof Flashing #11840 - 1 1/4" - 1 1/2" NO CAULK SOLAR FLASH

Leak Proof Permanent Seal Around 1/2", 3/4" & 1" Vent Pipe

24 Gauge Base

UV Resistant

For Roof Pitch 0 to 45 Deg.

Composition - Aluminum Base / No Caulk Polymer Collar

Galvanized Base No-Calk® Roof Flashings

Slides over pipe - for pitch to 40 degrees. Rustproof, stamped galvanized, 24 or 28 gauge. Non-fading sealing collar. 12 1/2" x 8 3/4" bases for code required areas. Rated 180°F continuous heat. ESM Flashings (only) have collar and base separate to allow for easier installation. Approved for Type B installations. Not for hot-mopped or built-up roofs. Do not use petroleum based products on collars.

Flashings - How To Use

Make sure roof is clean and free from any major protrusion

Before roof covering is installed:

No tar, asphalt-based roof cement or "pitch" should be applied to the collar portion of any metallic

No-Calk flashing or the base or collar portion of any Thermoplastic or Flexible No-Calk flashing.

At the discretion of the installer, silicone sealant can be applied over all exposed nails or staples.

Silicone sealant can also be applied to the underside of the base to increase sealing power to the roof

and is recommended in areas where frequent or heavy precipitation is common.

Place correct size No-Calk flashing over vent stack with angle facing down slope of the roof. Push firmly to base

of stack until flashing lies flat on the roof. Flashing size should be equivalent to pipe diameter size (i.e. 1.5"

flashing for 1.5" pipe, 2" flashing for 2" pipe size, etc...). The Oatey logo printed on the flashing represents the

front or down slope side of the flashing.

Using corrosion resistant nails or staples, secure the top of the flashing (the end closes to the crest of the roof) at

teach corner and along the sides at 4"-6" intervals to secure flashing to the roof. One nail or staple in each bottom

corner is appropriate. The top of the flashing will be covered one-quarter to one-half of the way down with

roofing shingles. The bottom edge of the flashing should overlap the shingles beneath it so it shed, not traps,

water.

Oatey Thermoplastic base flashings are designed to fit roof angles from flat to 45 degrees. Flexible, Galvanized,

Aluminum and Copper Base Flashings are designed to fit roof angles from flat to 38 degrees. Oatey All-Flash

High -Rise Thermoplastic Roof Flashings are designed to fit roof angles from flat to 60 degrees.